The go-around decision isn’t a failure, it’s a core pilot skill. Learn stabilized approach criteria, when to abort a landing, and how to decide with confidence.
Go-Around Decision: Why Going Around Is Professional Picture your first solo flight. You've finished the circuit, turned onto final, and then you notice you're above the glide path and a little faster than you should be.
One voice in your head says, "I can fix this." Another says, "Climb away and try again." Many trainees fear the second option because it feels like admitting a mistake in front of their instructor or the tower. But in aviation, the truth is the exact opposite: the pilot who goes around at the right moment is the pilot who understands the job .
In this guide, we explain what a go-around is, when to make the call, why even professional pilots hesitate, and how to build it into a habit from your first day of training. What Is a Go-Around? And How Is It Different from a Missed Approach and a Touch-and-Go?
A go-around is the decision to abandon a landing during final approach (or even moments before touchdown), apply power, and climb away to re-enter the pattern for another attempt, or divert to an alternate airport if needed. It isn't an emergency procedure, and it doesn't necessarily mean anything is broken.
It's a routine, trained maneuver, initiated by the pilot or requested by air traffic control, and you'll practice it from your earliest Private Pilot License (PPL) lessons. Three terms trainees often confuse Go-around: abandoning the landing and climbing away; the common term in flying under Visual Flight Rules (VFR).
Missed approach: the same idea under Instrument Flight Rules (IFR), but it follows a specific procedure published on the approach chart (heading, altitude, and holding fix). Touch-and-go: a planned training exercise where the wheels touch the runway and you take off again immediately. It's a drill, not a decision you make because the approach wasn't right.
For a deeper look at visual versus instrument flying, see our guide to VFR vs IFR in pilot training.
Why a Go-Around Is a Mark of Professionalism In modern aviation culture, the question asked after a flight isn't "Why did you go around?" but "Did you go around when you should have?" The difference between those two questions is the difference between a culture that shames the decision and one that rewards it. For the tower, a go-around is a normal, expected event.
Controllers always keep the climb-out path clear and re-sequence traffic within seconds. Nobody will ask you to justify it, and it won't be recorded against you as a "mistake." The math is simple: a go-around costs a few minutes and a little fuel. Forcing a landing from an unstable approach can cost a runway excursion, a hard landing that damages the aircraft, or worse.
There's no real comparison. The irony is that the statistics show the opposite of what you'd expect: Flight Safety Foundation data indicates that only a very small share of unstable approaches, around 3 to 5%, actually end in a go-around. In other words, most continue to landing even though the criteria weren't met. That's the problem we don't want you to be part of.
When to Decide: Stabilized Approach Criteria A stabilized approach means that at a defined point before the runway, the aircraft is on the correct path, at the correct speed, with an appropriate sink rate, fully configured for landing (gear and flaps), and aligned with the runway centerline. The industry uses "stabilization gates" at defined heights.
If you reach the gate and the criteria aren't met, the decision is already made: go around. But note: the exact heights and tolerances are set by the standard operating procedures (SOP) of your flight school or operator , in line with what the General Authority of Civil Aviation (GACA) approves. Your instructor is the reference for the numbers that apply to your aircraft.
5 signs it's time to go around 1 Airspeed outside tolerance Faster or slower than your aircraft's approach speed by more than the allowed margin. Too fast means a long landing; too slow brings you closer to a stall. 2 Wrong glide path or s…